Since entering China, it has provided thousands of customers with high-efficiencyMotor, High-voltage motors, variable frequency motors and other types of motors, these motors will have some failures that are inevitable in daily use.The motor is an electromagnetic device that realizes the conversion or transmission of electric energy according to the law of electromagnetic induction.Frequency conversion speed motorA general term for motors driven by frequency converters.In fact, the motor designed for the frequency converter is a special frequency conversion motor. The motor can achieve different speeds and torques under the drive of the frequency converter to adapt to the changes in the demand of the load.Explosion-proof motorsA type of motor that can be used in flammable and explosive plants, and it does not generate sparks during operation.Explosion-proof motors are mainly used in coal mines, oil and gas, petrochemical and chemical industries.In addition, it is also widely used in sectors such as textiles, metallurgy, city gas, transportation, grain and oil processing, papermaking, and medicine.There are many reasons for these failures. In order to avoid these failures, we must understand the reasons, resolve these failures, and slow down the loss.Motors is the largest authorized distributor in China. I have summarized the reasons for motor failures in many years of sales of motors, and I hope it will be helpful to you.
In the daily management and maintenance of the motor, we must often develop and clean the dust of the motor, and in the environment where the humidity is very large, the motor can be analyzed and dried frequently to avoid damage to the motor, or in the motor company. A heater is installed inside for dehumidification.
In practice, we sometimes see the oxide layer that can be seen in the motor due to broken wires and heat. This may cause damage to the wire insulation and affect the normal operation of the motor. We must find it immediately, tighten the screws and wires. Contact the wire to clean the oxide surface.
In addition to the above development, the maintenance and management personnel of the motor also told to keep a motor clean and free of oil and debris.This is because if we stick too much dust, fur, metal shavings, etc. to any of the components, it will cause heat generation or poor contact with the society after the work takes a period of time, and it will also increase the friction and friction of the clutch. damage.So I have to pay attention to regular system maintenance. You can use a brush to wipe the oil on the friction plate and other parts.
Thank you for reading this article,
